Driveway & patio resealing.
Bring colour, depth and protection back to your existing driveway. Resealing is the single most cost-effective thing you can do to extend the life of any surface.
Overview
What we do & why it lasts.
Sealer is what protects the surface of any block paving, imprinted concrete or resin driveway from UV, frost, oil and weed growth. Most sealers last 3–5 years before they need refreshing — and a faded, weed-bound drive almost always just needs cleaning and resealing, not replacing.
We clean, repair, re-sand and reseal in one visit. The right sealer choice depends on the surface and the look you want — matt for a natural finish, satin for a subtle depth, or wet-look for the rich, glossy finish you see on new installs.
Every reseal is done with high-grade UV-stable sealers and a fresh sand-up where needed. The result is a drive that looks years newer and is protected for the next 3–5 years.
Benefits
Why homeowners choose this finish.
Fraction of replacement cost
A reseal is typically 10–20% of the cost of a brand new driveway.
Restores colour
Block paving and imprinted concrete come back to their original deep colour, sometimes richer.
Locks out weeds
Combined with fresh kiln-dried sand, sealer hardens joints and stops weed growth at the source.
Protects the surface
UV, frost, oil and tyre marks bead off a freshly sealed surface instead of soaking in.
Typical applications
Where it works best.
From small front drives to large commercial forecourts, here is where we typically install this surface.
- Block paving driveways
- Imprinted concrete
- Resin bound rejuvenation
- Indian stone patios
- Concrete paths and yards
- Pool surrounds
- Commercial forecourts
- Garage and workshop floors
Our process
How the job runs, start to finish.
- 01
Survey & quote
We check the surface, identify the right sealer, and quote in writing — no pressure.
- 02
Deep clean
Pressure wash, treat moss and algae, lift stains and let the surface dry thoroughly.
- 03
Repair & re-sand
Replace any broken blocks, brush fresh kiln-dried sand into joints, then prep for seal.
- 04
Apply sealer
Two coats of UV-stable sealer in your chosen finish — matt, satin or wet-look.
FAQs
Common questions.
Where we work
Covering Manchester & the North West.
- Manchester
- Sale
- Altrincham
- Stockport
- Cheadle
- Wilmslow
- Bolton
- Bury
- Rochdale
- Oldham
- Wigan
- Warrington